Huntron Access RF Signal Measurement Prober provides reliable and repeatable near field measurements of RF signals. The system integrates a Huntron Access 2 Prober, Keysight spectrum analyser and Langer RF near field probes under the control of Huntron Workstation. This combination delivers an automated method to place a “sniffer probe” precisely where it is needed.
A Typical Application
Firstly, single point measurements in RF circuits are dependent on the manual dexterity and interpretation of the operator. The position of the RF probes must be duplicated to achieve repeatable measurements. The Huntron Access RF Signal Measurement Prober eliminates errors in probe placement. Therefore, documentation identifying the location of the probe points is not required. Hence, measuring points on your circuit board assembly (CCA). The Huntron Access RF will provide a minimum 10:1 improvement over manual methods.
Therefore, the CCA under test to be powered and in a functional state so measurements can be taken. The end user provides the PC, power supplies and control hardware based on their knowledge of the CCA. As a result, the size of the Access RF provides plenty of space to allow for cabling and connections to be made to the CCA. The Prober has a base plate cover that can be removed to allow for easy access to the probing area from below.
Not intended for EMC/EMI pre-compliance testing.
Technical Specifications Huntron Access RF Signal Measurement Prober
|Access RF Prober Specification||Access 2|
|Number of Test Heads||1|
|Maximum Board Under Test Size||56cm x 58cm|
|Maximum Probing Area||46.2cm x 56.9cm|
|Maximum Board Component Height||10cm|
|Dimensions||91.44cm W x 39.88cm H x 73.66cm D|
|Accuracy and Resolution||0.0007874″ (±20 microns) at 0.0003937″ (10 microns) minimum|
|Frequency range (N9935A with N9935A-235 preamplifier using included probes)||100 kHz to 3 GHz|
|Speed||Approx. 40 test points/minute at 1 measurement/point|
For more information, contact us.