EtherCAT CAN FD Interface Device

KRYPTONi-1xCAN-FD – EtherCAT CAN FD Interface

The KRYPTONi-1xCAN-FD is an EtherCAT CAN FD Interface.  CAN FD requirements in the Automotive Industry are increasing. Due to, the CAN FD Bus installations into new vehicles.  CAN FD is an exciting development as it significantly increases the bandwidth due to increased data clock rates and larger data payloads.

The KRYPTONi-1xCAN-FD is Dewesoft’s first CAN FD interface device and CAN FD analyser. It has a single CAN FD port.  Plus it uses EtherCAT as a data interface.  Therefore, devices can be daisy-chained together.  Using  a single EtherCAT cable for power, data, and synchronisation.

CAN FD is used by a large number of sensors inside the vehicle.  It is much faster than the normal CAN 2.0 which is limited to 1Mbps. The CAN FD supports high-speed CAN interface with data rates up to 8 Mbps.

CAN FD is also back-compatible.  Plus it supports the CAN 2.0 communication protocol.  As well as special protocols such SAE J1939, where CAN is used as read-only.

Consisting of galvanically isolated communication lines and an isolated sensor supply of +5 V and +12 V. Power limit for the sensor supply is 1.4 W.

This product is part of the  KRYPTON ONE product line. A line designed for extreme conditions with an operating temperature range between -40°C and +85 °C and IP67 rating.

KRYPTONi-1xCAN-FD device is supplied in a standard KRYPTON ONE chassis with a DSUB9 input connector.

Finally, for more information, contact us.

 

Leave a Reply

Your email address will not be published.